{"id":17427,"date":"2018-04-23T16:01:34","date_gmt":"2018-04-23T15:01:34","guid":{"rendered":"https:\/\/dynamitebaits.com\/ru\/uncategorised\/tie-multi-rig\/"},"modified":"2018-05-22T23:57:57","modified_gmt":"2018-05-22T22:57:57","slug":"tie-multi-rig","status":"publish","type":"post","link":"https:\/\/dynamitebaits.com\/ru\/carp\/tie-multi-rig\/","title":{"rendered":"Rig School – How to tie the Multi Rig"},"content":{"rendered":"

Its one of carp fishing’s most versatile and successful rigs. Want to know how to tie it? Follow our simple, step by step guide to tying the Multi Rig…<\/h3>\n

 <\/p>\n

What situation can you use Multi rigs for?<\/strong><\/p>\n

A brilliant and versatile rig that can be fished almost anywhere on any venue, whether it be to showing fish, low weed, silt and gravel.<\/p>\n

 <\/p>\n

What components do I need?<\/strong><\/p>\n

Out turned eyed hook  or chod hook. Some coated braid, a bit of tungsten putty, one hook bead, one bait screw or small swivel.<\/p>\n

 <\/p>\n

How do I tie a Multi-rig?<\/strong><\/p>\n

 <\/p>\n

Step 1. Take around 12 inches of your chosen coated braid.<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

Step 2: Make a large loop using a figure of eight knot, moisten the knot then pull tight using a puller tool.<\/strong>
\n Do the same at the other end to attach to your end tackle but keep this loop a bit smaller.<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

 <\/p>\n

Step 3: Strip back a few mm of the braid down to the large loop<\/strong><\/p>\n

 <\/p>\n

Step 4: Slide a hookbead onto the hook shank. This will help keep everything tidy once tied.<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

Step 5: Thread the braid loop (the large loop end) through the eye of the hook followed by a swivel or bait screw. Then pull the loop round and over the hook point and pull it down tight to the hook bead.<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

Step 6: Add your chosen pop-up to the bait screw or swivel. Our Foodbait pop-ups<\/a> are perfect for this rig<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

Step 7: Add some putty to the loop knot. This will critically balance the rig and create a rapid hooking effect when the carp sucks up the bait<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

The finished rig should look like this when in the water<\/strong><\/p>\n

 <\/p>\n

 <\/p>\n

 <\/p>\n